ION Cornerstone Glow Guide D'utilisation Rapide page 5

Bluetooth Pairing and Linking
Connecting to One Cornerstone Glow
1. Power on Cornerstone Glow by holding down the Power button. You will hear "Power On"
for confirmation. *
2. Press the Bluetooth Connect button briefly to enter Connecting Mode—the Bluetooth
LED will blink fast, and you will hear "Pairing" to indicate this. *
3. Navigate to your device's Bluetooth setup screen, find Cornerstone Glow, and connect.
Note: If you experience trouble in connecting, select "Forget this Device" on your
Bluetooth device and try to connect again. If your Bluetooth device is not able to connect
to Cornerstone Glow, hold the Bluetooth Connect button on the speaker to break previous
Bluetooth connections and reset the Bluetooth module. The Bluetooth LED will light up
solid when it is connected and you will hear "Pairing successful, connected" for
confirmation. *
4. To disconnect, hold the Bluetooth Connect button on Cornerstone Glow. You will hear
"Disconnected" for confirmation. *
Linking Two Cornerstone Glows
Note: Ensure that the speakers are not already Bluetooth-connected in Single mode
(described above). If either of them is connected, hold the Bluetooth Connect button to
disconnect and then follow the steps below.
1. Power on each Cornerstone Glow by holding down their Power buttons. You will hear
"Power On" for confirmation.
2. Press the Link button on each Cornerstone Glow. The speakers will search for each other
while playing an intermittent tone. Once the stereo pair is successfully linked, you will hear
"Pairing successful, connected" followed by "Left channel" and "Right channel" on the
respective speakers. *
This process may take up to 2 minutes the first time two speakers are linked. Speakers
that were previously linked will relink automatically in a few seconds if powered on in range
of one another.
Note: Cornerstone Glows should be within 30' (9.1 m) of each other to link properly.
3. On the Left speaker, the Bluetooth LED will blink. Press the Bluetooth Connect button
briefly to enter Bluetooth Pairing mode.
Note: The Left speaker will be the "master" speaker, and the unit from which the Bluetooth
range will be determined.
4. Navigate to your device's Bluetooth setup screen, find Cornerstone Glow, and connect.
You will hear "Connected" for confirmation. *
Note: If you experience trouble in connecting, select "Forget this Device" for Cornerstone
Glow on your Bluetooth device and try to connect again.
5. To disconnect linking, hold the Link button on the "master" Cornerstone Glow for 2
seconds. You will hear "Disconnected" for confirmation. *
Note: When two speakers are linked, hold the power button on the "master" speaker to
turn both speakers off. If you want to only turn off the "slave" speaker, press and hold the
power button on that speaker. The speakers will relink automatically the next time they are
both powered on.
* Tip: If you would like to disable (or enable) the voice prompts, simultaneously press the
Bluetooth Connect and Link buttons briefly.
5