Accessories; Cleaning And Maintenance; Cleaning - Sharp KH-6IX38FS00-EU Guide D'utilisation

cooking level, then press the "P" key to
activate the Boost function.
Switching the Bridge Zone off
To select the Bridge element, press the rear
left or front left heater selection button and,
using the left side of the sliding button, turn
the level down to "0". If the bridge cooking
zone is hot, "H" will be displayed.
Also right bridge element shall be
selected by pressing the rear right or
front right heater selection key with
using left side of the sliding button
key, turn the level down to ''0''. If the
bridge cooking zone is hot, "H" will be
displayed .
Error Codes
If there is an error, an error code will be shown on the
heater displays.
E1
Cooling Fan is disabled. Call an authorised
E3 Supply voltage is other than the rated values.
Switch the hob off by pressing
"H" disappears for all zones, switch the hob
on by pressing
the same error is displayed again, call an
authorised service agent.
E4 Supply frequency is different from the rated
values. Switch the hob off by pressing
, wait until "H" disappears from all
zones, switch the hob on by pressing
and continue to use. If the same error is
displayed again, switch the plug for the
appliance off and on. Switch the hob on by
pressing and continue to use. If the same
error is displayed again, call an authorised
E5 Internal temperature of the hob is too high,
switch the hob off by pressing
heaters cool down.
E6 Communication error between the touch
control and heater. Call an authorised service
E7
Coil temperature sensor is disabled. Call an
authorized service agent.
E8 Cooler temperature sensor is disabled. Call
an authorized service agent.
EA Large Coil Saturation Error. Switch the hob
off by pressing on/off button, switch the hob
on by pressing on/off button and continue to
use. If the same error is displayed again, call
an authorised service agent.
EC Supply Voltage Error.Switch the hob off by
pressing on/off button, switch the hob on by
pressing on/off button and continue to use.
If the same error is displayed again, call an
authorised service agent.
service agent.
,wait until
and continue to use. If
service agent.
and let the
agent.
C1-C8
Mcroprocessor alert. Switch the hob off by
pressing on/off button, switch the hob on by
pressing on/off button and continue to use.
If the same error is displayed again, call an

4.2 aCCeSSorieS

The Vitroceramic Glass Spatula
Always use the glass spatula to remove
spillages or deposits from the hob before
trying chemical cleaning agents. This is
the ideal method for removing even the
smallest deposits from the hob, and for
removing spillages from hot cooking zones
before they burn onto the hob.
Important: Always push the safety
cover back over the razor blade after use.
Take care when using the spatula and keep
it out of the reach of children.
5. CLEANING AND
MAINTENANCE

5.1 CleaninG

WARNING: Switch off the appliance
and allow it to cool before cleaning is
to be carried out.
General Instructions
• Check whether the cleaning materials
are appropriate and recommended by
the manufacturer before use on your
appliance.
• Use cream cleaners or liquid cleaners
which do not contain particles. Do not
use caustic (corrosive) creams, abrasive
cleaning powders, rough wire wool or
hard tools as they may damage the
cooker surfaces.
Do not use cleaners that contain
particles, as they may scratch the
glass, enamelled and/or painted parts
EN - 17
authorised service agent.