Connecting Pelco-Keyboard (Kbd200A/Kbd300A) - Security-Center EcoLine TV7090 Instructions D'installation

Connecting PELCO-keyboard (KBD200A/KBD300A)

Connect the RS-422 serial port (terminal TX +) from the control keyboard, to the Speed Dome Camera RS-
485 serial port (terminal D +). And connect the RS-422 serial port (terminal TX -) from the control
keyboard, to the Speed Dome Camera RS-485 serial port (terminal D -).
Normal Display Mode
Speed Dome Function
Focus Near
Focus Far
Iris +
Iris -
Pan Right
Tilt Down
Zoom Tele
Zoom Wide
OSD Setup Menu Mode
Speed Dome Function
Cursor Up
Cursor Down
Menu Enter
Menu Exit
Decrease (-)
Increase (+)
Speed Dome Function
Accessing Main Menu
Call up the Preset Points
Setting the Preset Points
AUTO SCAN
STOP SCAN
Call up Preset AUTO PAN
Stop Preset AUTO PAN
Please refer to PELCO Keyboard (KBD200A/ KBD300A) manual for more information.
Pan Left
Tilt Up
None
None
None
None
PELCO Keyboard
Move Joystick Left
Move Joystick Right
Move Joystick Up
Move Joystick Down
Twist Joystick clockwise
Twist Joystick counterclockwise
PELCO Keyboard
Move Joystick Left
Move Joystick Right
Move Joystick Up
Move Joystick Down
Twist Joystick clockwise
Twist Joystick counterclockwise
PELCO Keyboard Operation
Enter 95; Hold the PRESET key (approximately five
seconds) until the main menu appears on the screen.
Enter preset number (1~32, 35~82) and press
PRESET to put camera in preset position.
To program, position camera, enter desired preset
number (1~32,35~82), and hold down PRESET for
two seconds.
Enter 99 and press PRESET
Enter 96 and press PRESET
Enter group number (1~6) and press PATTERN
21
NEAR
FAR
OPEN
CLOSE
NEAR
FAR
OPEN
CLOSE
Press ACK