Alarm Management; Alarm Input; Alarm Output; Stop Alarm Condition - Security-Center EcoLine TV7090 Instructions D'installation

ALARM MANAGEMENT

ALARM INPUT

The speed dome camera is equipped with six alarm input connectors. These connectors correspond to both
preset positions and auto pan groups.
NOTE: To choose the correspondant funtion (auto pan group / preset position) go to the OSD of the
keyboard and set the function accordingly.
Once the alarm signal is detected the speed dome camera will automatically move to the preset position or
start up the auto pan group. In addition the alarm buzzer and the LED of the
button is activated
The keyboard's LCD displays:
The monitor picture displays the message „ALARM". The message disappears as soon as the position of the
dome camera is changed.
NOTE: By activating multiple alarm inputs at the same time the dome camera will move to the
position that is related to the latest activated alarm input.

ALARM OUTPUT

The alarm output (NO/NC) is activated accordingly to the alarm input.

STOP ALARM CONDITION

Stopping the alarm condition (and resetting the alarm output) can be done in two ways.
a) Manualyy by pressing the button
will turn off.
b) Automatically after the preset alarm time.
NOTE: Set the alarm time in the keyboard's OSD.
⎡
DEVICE : XXX
⎢
ALARM INPUT
⎣
EVENT RESET
17
EVENT RESET
⎤
⎥
⎦
(LED is deactivated). Also the alarm buzzer