After Use - SOLAC PP7252 Mode D'emploi

PP7252.book Page 12 Thursday, July 30, 2009 2:01 PM
To curl tips outwards (Fig. 5)
1 Place the tip of the lock of hair between the plates and close them.
2 Turn the straightener outwards as if it were a hairbrush.
3 Keep it in this position for a few seconds.
To curl tips inwards (Fig. 6)
1 Place the tip of the lock of hair between the plates and close them.
2 Turn the straightener inwards as if it were a hairbrush.
3 Keep it in this position for a few seconds.
To add body (Fig. 7)
1 Place the lock of hair between the plates at the roots and close them.
2 Place the lock of hair in vertical position with a slight forward movement
to add the desired volume.
To wave (Fig. 8)
1 For a wavy or curly look, separate vertical locks so the curls fall more
naturally.
2 Take thicker sections for bigger curls or natural-looking waves and finer
strands for romantic ringlets and tighter curls.
3 Wrap each lock of hair around the straightener using a circular motion
(as through it were a round brush) to get a wave and ringlet-shaped lock.
4 Wrap the hair around as you slide the straightener downwards.

5 After Use

1 Switch off the straightener using the on/off button (1).
2 Unplug the appliance.
3 You can use the thermal bag to store the straightener, even if the plates
are still hot.
6 Cleaning and Storage
)
Only clean the appliance when it is cold. Do not use solvents, detergents
or abrasive products.
1 Unplug the appliance.
2 Use a dry cloth to clean the outside.
3 Clean the plates with a damp cloth and then dry them.
12 After Use