Varan XM-1010 Manuel D'utilisation page 19

STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the same as that shown on the specification plate of the machine
and that switch is "OFF" before connecting the tool to the power circuit.
Switching the machine on and off
To switch on:
While holding with the left hand on the column and the right hand on the main handle,Press the rocker
switch to the "on" position.Anticipate and be ready for the start up torque when the machine first starts.
To switch off:
Press the rocker switch to the "OFF"position.After the machine has been switched off,the grinding wheel will
still rotate for a time.Take care that parts of your body do not come into contact with the wheel and do not
set the machine down while it is still rotating!
Adjusting the rotation speed:
The speed of the machine is variable to suit different tasks.It can be adjusted from 2500/min up to 5000/min
by using the thumb wheel,turn in the downward direction to increase the speed and in the upward direction
to decrease the speed.Generally,you should use the higher speed for fast stock removal and the lower speed
for more precise control.
HOW TO USE THE TOOL
Effective control of this machine requires two-handed operation for maximum safety and control.
The proper hold is to keep one hand on the main handle and the other hand on the sponge grip on the
column or the bail handle.It is vitally important to keep stable footing at all times,especially when standing on
scaffolding or stilts.
GRINDING OPERATIONS
1.Once the machine and vacuum cleaner are set up and all safety measures and equipment are in place,begin
by turning on the vacuum cleaner and then the machine.(If you are using a vacuum cleaner with integrated
switching,then simply turn the machine on.)
Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
XM-1010
T: 00352/26908036 – F: 00352/26908040