Functional Description; Technical Specifications; Electrical Connection - Varan XM-1010 Manuel D'utilisation

2.Prolonged breathing of airborne dust from grinding operations may effect respiratory function:
Always use a vacuum cleaner with a bag approved for fine dust installed.
Always wear a respirator approved for dust and mist.
3.Grinding lead-based paint is extremely toxic and should not be attempted.
Only allow professionals with special training and equipment perform this task.
4.Maintain proper footing and balance at all times.
Do not overreach.Use proper scaffolding
5.Aways wear appropriate safety equipment when operating.
6.Important:After completing operation,switch off the switch and wait for the coasting disc to stop
completely before putting the tool down.
7.Never operate the tool in an area with flammable solids,liquids, or gases. Sparks from the
commutator/carbon brushes could cause a fire or explosion.
8.There are certain applications for which this tool was designed. The manufacturer strongly recommends
that this tool Not be modified and/ or used for any application other than for which it was designed. If you
have any questions relative to its application DO NOT use the tool until you have written the manufacturer
and have been advised.
9.Use the machine with both hands at all times.Loss of control can cause personal injury.
10. Keep power supply cord clear from the working range of the machine.Always lead the cable away
behind you.
11. Immediately switch off the machine if unusual vibrations or if other malfunctions occur.Check the
machine in order to find out the cause.
12. The dust that arises when working with this tool can be harmful to health.Use a dust absorption
system and wear a suitable dust protection mask and remove deposited dust with a vacuum cleaner.

FUNCTIONAL DESCRIPTION

This Long-Reach Diamond Grinder is specially designed for the minimum effort and maximum speed in
grinding difficult to reach areas. It is designed to work in conjunction with a vacuum cleaner for minimum
dust and maximum efficiency. The pivoting grinding head allows it to follow surface contours for ease of
handling.
SPECIFICATIONS

TECHNICAL SPECIFICATIONS

Length: 110-160CM
Valtage:230V
Frequency：50HZ/60HZ
No load speed: 1700-3500/min
Power input:1010W
Diamond cup wheel:125mm
Net Weight:4.4KG

Electrical connection

The network voltage must conform to the voltage indicated on the tool name plate.Under no circumstances
should the tool be used when the power supply cable is damaged.
Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
XM-1010
T: 00352/26908036 – F: 00352/26908040