Cutting Preparation - Romus MH-630 Manuel D'utilisation

Cutting Preparation

Adjust the angle attachment as
needed and pull the extension
handle out as shown.
The angle attachment can be used
on left side of the table as shown.
Warning: Do not put your fingers
against the sharp edge of the blade
at any time.
Straight Cutting
Insert material between the
cutting blade and the base, flush
with the angle attachment as
shown and hold the material with
foot then push handle down to
complete a cut.
Warning: Maintain control of the
handle. Do not allow handle to
slam back after making a cut.
45° Cutting
Adjust the angle attachment to
45°. Insert material between the
cutting blade and the base,
against the angle attachment as
shown, then push the handle
down to complete a cut.
Warning: Maintain control of the
handle. Do not allow handle to
slam back after making a cut.
CUTTING