Changing The Blade - Romus MH-630 Manuel D'utilisation

Installation of the Cutter
Pull up the lock pin on the
aluminum handle as shown and
insert the handle into the
handle base as shown.
Warning: Do not put your
fingers against the sharp edge
of the blade at any time.

Changing the Blade

Use the provided Allan wrench to
remove the nine screws, then
hold the blade by each end and
carefully remove the blade out of
the blade holder.
Note: The flat side of the blade
faces the table.
Warning: Do not put your fingers
against the sharp edge of the
blade at any time.
Carry
Hook the chain to the ring on
the handle and carry the cutter
as shown.
SET UP