OmniPod DASH Guide De L'utilisateur page 18

Omnipod DASH System Instructions
XXXXX
Activate a new Pod
XXXX
Apply the Pod
1. Select the infusion site, being careful to avoid
areas where the Pod will be affected by folds of
skin. Refer to the Pod Placement section of this
User Guide for sites and placement tips.
Tip
Use the Pod site map to help you track your
current and recent Pod site locations. This feature
can be turned on in Settings.
If the Personal Diabetes Manager screen times out during the process,
18
4. Leave the Pod in its plastic tray
- Insert the needle straight down into the fill port
on the underside of the Pod. To ensure proper
filling, do not insert the fill syringe at an angle
into the fill port.
- Completely empty the syringe into the Pod
- The Pod will beep twice, indicating that the
Omnipod DASH System is ready to proceed
- Return to the PDM. If the PDM screen times out,
press the Power button to turn it back on. Place
the PDM next to the Pod so they are touching.
- Tap NEXT
5. The PDM establishes a one-to-one relationship with
the Pod, which will prevent it from communicating
with any other Pod while this Pod is active. Once
the Pod successfully completes its priming and
safety checks, the PDM will beep.
Reminder
During activation and priming the PDM and Pod
should be next to each other and touching.
press the Power button to continue.