Care And Maintenance - Danby Designer DFF311WDD Guide D'utilisation Et Soins De Propriètaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

COOLING SYSTEM
This refrigerator is equipped with a "Frost Free" type cooling
system, which means you never have to defrost the freezer
compartment. Defrosting is done automatically. The defrost
water is routed into a defrost pan located directly above the
compressor, where it then evaporates.
CLEANING
Before cleaning the refrigerator or freezer, always
disconnect the refrigerator from the power supply. To clean the
inside, use a soft cloth and a solution of a tablespoon baking
soda to one quart (4 cups) of water, or a mild soap suds solu-
tion or mild detergent. Wash ice cube tray, drip tray, and glide
out shelves in a mild detergent solution, then wipe dry with a
soft cloth. Clean the outside with a damp soft cloth and some
mild detergent or appliance cleaner.
SETTING THE THERMOSTAT
The thermostat setting can be adjusted from 1
(minimum setting) through Maximum (coldest
setting). We recommend setting the thermostat at 4 (medium
setting). However, if you find this setting inadequate for your
cooling requirements, adjust as needed by rotating the ther-
mostat dial. The thermostat dial is located on the front top sec-
tion of the refrigerator compartment.The thermostat controls
temperature for both the freezer and refrigerator compart-
ments. After making adjustment, wait 24 hours for new tem-
perature to stabilize before making another adjustment. You
will also see another temperature dial in the freezer compart-
ment; leave it in the middle (FREEZER) as that is the factory
recommended setting.
REFRIGERATOR
4
6
VACATION TIME
For short vacation periods, leave the control knob at the usual
setting. During longer absences;
a) remove all food,
b) disconnect from electrical outlet,
c) Tape rubber or wood blocks to the top of the door to
prop it open far enough for air to get in. This stops odor
and mold from building up.
POWER FAILURE
Most power failures are corrected within an hour or two, and
will not affect your refrigerator temperatures. However, you
should minimize the number times you open the door while
the power is off. During power failures of longer duration, take
steps to protect your food, for example, by placing dry ice on
top of packages.
IF YOU MOVE
Remove, or securely fasten down, all loose items inside the
refrigerator. To avoid damaging the leveling legs, turn them all
the way into the base.

CARE AND MAINTENANCE

FREEZER
MIN
MAX
CONGÉLATEUR
Recommended Setting
SOME IMPORTANT RULES FOR THE CORRECT USE OF
THE REFRIGERATOR
• Never place hot foods in the refrigerator
• Beverages should be stored in sealed containers
• Foods to be stored for a long time should be wrapped in
cellophane or polyethylene, or kept in glass containers.
Never place spoiled food in the refrigerator.
• Don't overload the refrigerator.
• Don't open the door unless necessary.
• Should the refrigerator be stored without use for long
periods, it is suggested, after careful cleaning, to leave the
door ajar to allow the air to circulate inside the unit in order to
avoid the possible formations of condensation, mold, or
odors.
FOOD STORAGE SUGGESTIONS: Fresh Food Compartment
• Never cover food compartment shelves with aluminum foil or
any other shelf covering material which may prevent air
circulation.
• Always remove porous store wrapping paper from meats,
poultry, and fish. Meats should be wrapped individually and
placed in a dish for storage. Wrap fish and poultry in foil or
heavy waxed paper. Most fish should be used the same day
of purchase. Packaged meats such as ham, bacon, dried
beef, or frankfurter, store best in their original packages.
• Allow warm foods to cool to room temperature before
placing them in the refrigerator.
• Always cover open dishes of food, especially leftovers.
Use leftovers within 2 or 3 days.
VEGETABLE CRISPER
The tray at the bottom of the refrigerator is covered to retain
moisture. The crisper compartment will enable you to store
vegetables and fruits which would otherwise dry out rapidly.
The humidity level inside the crisper drawer can be controlled
by adjusting the "damper" control (white slider) located on the
front of the drawer. For leafy vegetables, increase the humidi-
ty by closing the slide. For fruits, decrease the humidity by
opening the slide.
4

Publicité

Table des Matières
loading

Table des Matières