Installation Requirements; Tools And Parts; Options; Location Requirements - KitchenAid PRO LINE KHWV01RSS Guide D'utilisation Et D'entretien

Tools and Parts

Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
Pliers that open to
1⁹⁄₁₆" (3.95 cm)
Tools needed for installation
Adjustable or open end
wrenches, 13 mm and
⁹⁄₁₆" (14 mm)
#3 Phillips screwdriver
Parts supplied
A
B
C
D
A. Door handle
B. Door handle washers (2)
C. Door handle screws (2)
Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, call the toll-free
number on the cover or in the "Assistance or Service" section.
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller available)
than 96" (2.4 m)
Overhead sewer Standard 20 gal. (76 L), 30" (76.2 cm) tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain Siphon break, Part Number 285834;
additional drain hose Part
Number 8318155; and connector kit, Part
Number 285835
Drain hose too 4 ft drain hose extension kit, Part
short Number 285863
Water faucets 2 longer water fill hoses:
beyond reach of fill 6 ft (1.8 m) Part Number 76314,
hoses 10 ft (3.0 m) Part Number 350008
4

INSTALLATION REQUIREMENTS

Flashlight (optional)
Ruler or measuring tape
Wood block
Level
E
D. Cable tie
E. Transport bolt hole plug (4)
F. Inlet hose (2)
A pedestal may be purchased separately for this washer. This
pedestal will add about 11" (27.9 cm) to the height of your
washer for a total vertical height of approximately 53" (134.6 cm).
To order, call the dealer from whom you purchased your washer
or refer to the "Assistance or Service" section of this manual. Ask
for Model Number LAV2701RSS.
F
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, in a
basement, laundry room, closet, or recessed area. See "Drain
System."
IMPORTANT: Do not install or store the washer where it will be
exposed to the weather.
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
A water heater set to deliver 120°F (49°C) water to the
washer.
A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
Hot and cold water faucets located within 5 ft (1.5 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa).
A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on carpeting is not
recommended.
A sturdy floor to support the washer with a total weight
(washer, water and load) of 550 lbs (249 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures. See "Washer Care" for winterizing information.

Options

Optional pedestal

Location Requirements