Pausing Or Restarting; Changing Cycles, Options And Modifiers; Status Display - KitchenAid PRO LINE KHWV01RSS Guide D'utilisation Et D'entretien

Pausing or Restarting

1. To pause the washer at any time, select PAUSE/CANCEL.
2. To continue the cycle, select and hold START (for
approximately 1 second).

Changing Cycles, Options and Modifiers

You can change the Cycle before START is selected. You can
change the factory default settings for the Modifiers (Soil Level,
Temp, and Spin Speed) and Options anytime before START is
selected and during the wash cycle.
NOTE: To help protect your garments, not all Options and
Modifiers can be selected with all wash cycles.
Cycles, Options and Modifiers can be changed anytime before
START is selected.
To cancel a cycle and select a new cycle
1. Select PAUSE/CANCEL twice.
2. Select desired cycle.
3. Select the desired Options.
4. Select and hold START (for approximately 1 second) to restart
the washer at the beginning of the new cycle.
To cancel a cycle
1. Select PAUSE/CANCEL twice.
2. The washer powers down, the door unlocks, and clothes can
be removed.
NOTE: If the water level or the temperature is too high, the
washer will drain automatically before the door unlocks.
To change Options or Modifiers after the cycle has
started
1. Select PAUSE/CANCEL.
2. Select the desired Options or Modifiers.
3. Select and hold START (for approximately 1 second) to
continue the cycle.
NOTE: Options and Modifiers can be changed anytime after
START is selected and before the start of the selected Option or
Modifier.
To drain the washer manually
1. Select PAUSE/CANCEL.
2. Select DRAIN/SPIN.
3. Select and hold START (for approximately 1 second) to begin
the drain.
4. When the spin is complete, the door unlocks. Items can be
removed from the washer.
14

Status Display

Messages on the status display help you to follow the progress of
your washer. They also indicate when you can add an additional
item to the wash cycle and when the controls are locked.
Adding items
You can add items to the washer after the cycle has started for
Rapid Wash, Normal/Casual, Heavy Duty, White/Cotton, and
Sanitary if ADD A GARMENT message is displayed.
To add items
1. Select PAUSE/CANCEL. The washer door unlocks, and items
can be added.
2. To continue the cycle, close the door and select and hold
START (for approximately 1 second).
Cycle Complete
The CLOTHES CLEAN status message is displayed for 5 minutes
after the cycle is complete. The washer will then power down.
Locking controls
The Control Lock avoids unintended use of the washer. You can
also use the control lock feature to avoid unintended cycle or
option changes during a cycle. When the locked icon appears in
the display, all buttons are disabled except for Pause/Cancel and
Start. You can lock the controls while the washer is operating.
To lock the controls
Select and hold DRAIN/SPIN for 3 seconds.
The CONTROL LOCK icon illuminates.
To unlock the controls
Select and hold DRAIN/SPIN for 3 seconds until the CONTROL
LOCKED icon disappears.
Estimated Time Remaining
The cycle times vary automatically based on your water pressure,
water temperature, detergent, and clothes load. The cycle time
will be extended if oversudsing occurs or the load is unbalanced.