Electromagnetic Fields (Emf) - Philips FC9910 Mode D'emploi

1
1
1.0.3 Caution
When you use the robot to vacuum fine sand,
lime, cement dust and similar substances, the
pores of the filters become clogged. As a result,
error code E6 may appear on the display (see
chapter 'Error codes').
• Never use the robot without the filters. This
could damage the motor and shorten the
robot's life.
•
Only use the mains cord, the adapter and the
base station supplied to charge the robot.
•
Do not cover the infrared signal generator
and infrared signal emitter of the base station
with stickers or by placing something in front
of them. if you do, the robot and the base
station cannot communicate with each other.
•
Do not cover the camera or the sensors on
the robot, as this prevents it from finding its
way and from communicating with the base
station.
•
Always switch off the robot by setting the on/
off switch on the bottom to OFF before you
transport or store it.
•
Remove the rechargeable battery from the
2
robot if you are not going to use it for some
time.
•
Do not operate the robot in a dark room, as
it needs light to navigate.
•
The robot can be used on carpets with a pile
depth of up to 20mm. however, the robot
may move more slowly on carpets than on
hard floors.
2
1.0.4 Electromagnetic fields (EMF)
The robot complies with all standards regarding
electromagnetic fields (EMF). If handled properly
and according to the instructions in this user
manual, the robot is safe to use based on scientific
evidence available today.
1
1
max.
20mm
2
2
5