Front Panel; Before Use - JB Systems ME 2 Mode D'emploi

ENGLISH
OPERATION MANUAL
FEATURES
• 11 inputs on 5 channels (5line, 2phones, 4micros)
• 4 stereo channels with selectable inputs
• 1 separate balanced DJ micro with talkover
• Crossfader on channels 3 & 4
• 3 band equalizer on master output
• Digital echo with delay, repeat & effect controls
• Analog VU-meters with blue lighting
• Pre-fade listening

BEFORE USE

Check the contents:
Check that the carton contains the following items:
• ME2 Mixer unit
• Operating instructions
Some important instructions:
• Choose the place where you put your installation very carefully. Avoid presence of
heat sources. Avoid places with vibrations or places that are dusty and humid.
• To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
• In order to prevent electric shock, do not open the enclosure. If a problem occurs,
contact your dealer.
• Do not place metal objects or spill liquid inside the mixer. Electric shock or
malfunction may result.
CONNECTIONS
Except for microphones and headphone, all connections are cinch. Use good quality
cinch-cinch cables to prevent bad audio quality. (example: JB Systems code: 2-0370)
For more information on connections, please refer to the next chapter.
Be sure to turn off the mixer before you make changes to the different connections.
In this manual we talk about "line inputs". This is a global name for inputs with a level
between 750mV and 2V. This includes tuners, videos, CD-players, etc.
JB SYSTEMS
OPERATION MANUAL
1/20 ME2 MIXER
ENGLISH

FRONT PANEL

1. Power (Power ON/OFF switch): Used to turn on the power of the mixer.
2. VU-meters: Used to monitor the level of the different audio signals. With the
channel faders you can change the input level of each connected audio source.
Make sure the levels do not exceed 0dB (or 100%). The audio risks to be
distorted when the signal level comes in the red zone of the VU-meter. You can
also use the VU-meter to compare the signal level of the input channels with that
of the master output.
3. Equalizer on/off switch: Used to switch the 3band equalizer on and off. The
equalizer works on the mixed output signal.
4. Equalizer controls: When the equalizer is switched on, you can use these 3
faders to change the audio to your personal taste.
5. Echo on/off switch: Used to switch the internal echo effect on and off. The echo
effect works on the mixed output signal.
6. Echo level control: Used to control the level of the echo signal that will be mixed
with the original. Use it to make the perfect balance between the original and the
effect signal.
7. Echo repeat control: Used to control the feedback or number of echoes you
want to create. Together with the delay time (8) you will be able to create the
echo you desire.
8. Echo Delay time: With this control you can set the length of the delay time.
Together with the repeat time (7) you will be able to create the echo you desire.
9. Cue selector: Used to select the source you want to monitor. You can listen to
any input channel while its channel fader is closed.
10. Cue level: Used to control the output level of the headphone output.
JB SYSTEMS
OPERATION MANUAL
2/20 ME2 MIXER