Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
With the POWER-switch, you can switch the device on and off.
Procedure:
Step 1: Unscrew the fixation screws of the service lid on top of the housing.
Step 2: Remove the service lid.
Step 3: Remove the dry sponge from the liquid container and soak it in a fragrance of your choice. The
sponge should not drip, however!
Step 4: Insert the moist sponge into the liquid container.
Step 5: Replace the service lid and tighten the screws.
Connection with the mains
Connect the device to the mains with the power plug.
The occupation of the connection cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Do not operate this device with opened service lid!
International
L
N
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
12/24
00027031.DOC, Version 1.1
Publicité
Table des Matières
