Refrigerator Use; Using The Controls - Whirlpool WRB551WNBS Guide D'utilisation Et D'entretien

Refrigerator Door
1. Place the refrigerator door onto the center hinge pin.
2. Using the hex key and the internal hex head screw, removed
earlier, fasten the top hinge to the top of the refrigerator door.
3. Reinstall the hinge hole plug on the opposite side of the
refrigerator door.
Final Steps
1. Check all holes to make sure that hole plugs and screws are in
place and are fully tightened.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. Plug into a grounded 3 prong outlet.
3. Return all removable door parts to door and food to
refrigerator.

REFRIGERATOR USE

Using the Controls

The control panel is located at the top front of the refrigerator
compartment.
IMPORTANT:
After you plug in the refrigerator, it automatically begins to
cool.
The indicator LEDs on the control panel light up for
approximately 1 second, and following the initialization
process the temperature set point is displayed.
The recommended temperature setting should be correct for
normal household refrigerator use. The controls are set
correctly when milk or juice is as cold as you like and when ice
cream is firm.
Wait at least 24 hours for your refrigerator to cool completely
before adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.
If the temperature is too warm or too cold in the refrigerator or
freezer, first check the air vents to be sure they are not
blocked before adjusting the controls.
Temperature Controls
For your convenience, the temperature control is preset at the
factory. When you first install your refrigerator, make sure the
controls are still set to the recommended setting as shown.
Recommended Setting "Middle"
A. Temperature control button
Temperature Selection
If you want to adjust the temperature in both the freezer and
refrigerator compartments, use the temperature settings listed in
the chart below as a guide.
Press the temperature control button to toggle through the
temperature selections from High (least cold) to Middle (colder) to
Low (coldest).
NOTE: Do not adjust the control more than one setting at a time.
Wait 24 hours between adjustments for the temperature to
stabilize.
DISPLAY
A
TEMPERATURE
High
Mid-High (Eco Green)
Middle (Recommended)
Mid-Low
Low
9