Publicité
9.5
VERTI-GROOM DRIVE BELT __________________________________________
The drive belt is found on the right side of the machine. To
access, remove the lid from the drive belt housing.
ADJUST THE VERTI-GROOM DRIVE BELT:
Loosen the belt tensioner. Apply a force of 2.2Kgs
(5lbs) in the centre of the lower length [A]. Set the belt
tension to a deflection of 5mm (3/
REPLACE THE VERTI-GROOM BELT
1.
Pull on the clutch knob to disengage Verti-Groom
drive clutch. Move the belt into the gap. Move the
drive belt pulley lip on to the Verti-Groom shaft.
2.
Clear dirt out of pulley.
3.
Put the Verti-Groom drive belt on to the Verti-Groom clutch handwheel and pulley. Put the new belt over
the Verti-Groom shaft pulley. Turn the clutch handwheel to put the drive belt on to the pullley.
4.
Adjust - see above.
5.
Replace all The covers before you run the machine.
9.6
VERTI-GROOM LUBRICATION_________________________________________
Check all nuts and bolts every 75 hours.
Lubricate these points with general purpose Lithium
grease.
Each week or every 25-work hours.
A:
Drive belt housing.
Verti-Groom link.
Grooved roll.
NOTE: DO NOT OVER GREASE.
in).
16
9 ACCESSORIES
A
A
en-51
Publicité
