Rear Panel - Denon Professional DN-108LF Guide D'utilisation

Subwoofer Diagram
Top Panel
Attachment Screws

Rear Panel

Steel Backcan
Installation
To ensure a reliable installation, please follow these steps carefully:
1. Assemble the subwoofer mounting bracket (see graphic below) by taking one of the alignment beams
and sticking it under the groove in the "C" shaped subwoofer mounting bracket. Place in the desired
install location and use 2 screws and 2 washers to connect. Repeat this process on the other side
while making sure the holes line up evenly.
2. Determine the subwoofer position, taking into account any obstructions in the ceiling space. Note that
a clearance of 8.7" (222 mm) above the lower face of the ceiling is required. The cutout diameter is
10.7" (273 mm).
3. Remove the ceiling space and position the subwoofer mounting bracket so that the "C" shaped
subwoofer mounting bracket fits the hole that you cut. Use a metal safety wire with a snap hook (sold
separately) and loop it around a truss/beam on one end. Use a screw to mount the safety wire by
fastening the subwoofer mounting bracket into the truss/beam that the safety wire is looped around.
Make sure the screw head covers the surface area of the screw hole.
4. Remove the supplied 4-pin Euroblock from the subwoofer and connect it to the subwoofer cable
(see graphic below).
Tap Selector
Euroblock
Subwoofer
Safety Hook
Rotating Mounting Tabs
5