Télécharger Imprimer la page

Publicité

Liens rapides

Installation
Instructions
Questions? In the U.S., call 800.GE.CARES (800.432.2737)
In Canada, call 1.800.561.3344
❒ BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
— Save these instructions
for local inspector's use.
IMPORTANT
— Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions for future
reference.
• Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time – 1 to 3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
• This kit is UL/CSA listed for installation alone or over any
GE/GE Profile single electric wall oven. Not for use adjacent
to (within 2 feet of) any gas or electric range, cooktop
or oven.
• For easier installation and personal safety, we
recommend that two people install this microwave oven.
• Unplug the microwave oven before attempting installation
of this kit.
• This kit is for use on models: PEB1590DMBB,
PEB1590DMWW, PEB1590SMSS, PEB159CDNBB,
PEB159CSNSS and PEB159CDNWW.
• Do not alter or modify any part of this kit or the oven.
WARNING
— This oven must be plugged into a
properly grounded 3-hole, 120V receptacle as required by
the National Electrical Code or Canadian Electrical Code.
FOR YOUR SAFETY:
WARNING
— Before beginning the installation,
switch power off at service panel and lock the service
disconnecting means to prevent power from being switched
on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
All manuals and user guides at all-guides.com
Built-In Trim Kits
JX1527 JX1530
or Visit our Website at:
1
or Visit our Website at:
GEAppliances.ca.
PARTS INCLUDED
PART
❒ Trim Frame
❒ Bottom Duct
❒ Top Bracket
❒ Bottom Bracket
❒ Upper Duct
❒ Rear Duct
❒ 4 mm x 14 mm
Round-Head
Screws
❒ 4 mm x 14 mm
Flat-Head
Screws
❒ Anti-Tip Brace
❒ Anti-Tip Bracket
❒ Template
NOTE: This kit has extra screws to prevent the technician
from spending extra time locating a replacement screw
during installation.
KEEP THESE INSTRUCTIONS.
ge.com.
QUANTITY
1
1
1
1
1
1
22 required
2 extra
4 required
2 extra
1
1
1
READ CAREFULLY.

Publicité

loading

Sommaire des Matières pour GE JX1530

  • Page 1 Warranty. • This kit is UL/CSA listed for installation alone or over any ❒ Upper Duct GE/GE Profile single electric wall oven. Not for use adjacent to (within 2 feet of) any gas or electric range, cooktop or oven.
  • Page 2 All manuals and user guides at all-guides.com Installation Instructions ❒ TOOLS YOU WILL NEED CUTOUT DIMENSIONS (CONT.) ″ on all sides for overlap On 27″ models, allow 1 ⁄ of the trim frame over the edges of the cutout. ❒ #2 Phillips Screwdriver ″...
  • Page 3 All manuals and user guides at all-guides.com Installation Instructions ❒ ❒ INSTALL BOTTOM DUCT ASSEMBLY INSTALL UPPER DUCT AND TOP TO MICROWAVE OVEN BRACKET Fasten the anti-tip bracket to the bottom duct Remove two screws from back of the using four round-head screws. microwave oven.
  • Page 4 All manuals and user guides at all-guides.com Installation Instructions ❒ ❒ CHECK LEVELING INSTALL THE TRIM FRAME Check the leveling by placing a level at the front Place the trim frame over the microwave oven and sides of the microwave. It may be necessary to with the vent openings at the bottom.
  • Page 5 électrique simple GE ❒ Conduit supérieur ou GE Profile. Ce four à micro-ondes ne peut être installé à moins de 2 pieds d’une cuisinière au gaz ou électrique, d’une surface de cuisson ou d’un four.
  • Page 6 All manuals and user guides at all-guides.com Instructions d’installation ❒ OUTILS NÉCESSAIRES DIMENSIONS DE L’OUVERTURE (SUITE) Sur les modèles de 27 po, prévoyez un espace de 1 ⁄ po sur tous les côtés pour permettre le chevauchement du cadre de finition ❒...
  • Page 7 All manuals and user guides at all-guides.com Instructions d’installation ❒ ❒ MONTAGE DU CONDUIT INFÉRIEUR MONTAGE DU CONDUIT SUPÉRIEUR DU FOUR À MICRO-ONDES ET DU SUPPORT SUPÉRIEUR Fixez le support antibasculement au conduit inférieur au Retirez les deux vis à l’arrière du four à micro-ondes. moyen de quatre vis à...
  • Page 8 All manuals and user guides at all-guides.com Instructions d’installation ❒ ❒ VÉRIFICATION DU NIVEAU MONTAGE DU CADRE DE FINITION Pour vérifier la mise à niveau, placez un niveau à l’avant et sur les Placez le cadre de finition sur le four à micro-ondes en côtés du four à...

Ce manuel est également adapté pour:

Jx1527Jx1527cbh