Publicité
7. Troubleshooting
Pa per jam
You have fed in too much paper.
Caution!
1
Do not press rocker switch alter-
2
nately forwards/backwards
(pos. 1 / pos. 2):
Cutting unit can be damaged.
• Press and hold down rocker
2
switch pos. 2.
• Pa per is pus hed out.
• Se pa ra te pa per stack.
1
• Press rocker switch pos. 1.
• Feed pa per successively.
Cut material container full
• Paper shredder switches off
Empty the cut material container,
because if it is too full, malfunc-
tions can occur in the cutting sys-
tem
• Tap rocker switch pos. 2.
2
• Empty full shredded material
container.
Shredded material container con-
tact interrupted
• Paper shredder switches off.
• Check whether shredded
material container is correctly
inserted in bottom frame.
If other faults occur, please check the follow-
ing before calling our customer service:
• Is mains plug in ser ted?
• Is rocker switch tur ned on?
• Is the mo tor over lo aded?
al low mo tor to cool down for 15 - 20 min.
0705
All manuals and user guides at all-guides.com
Paper shredder
english
8. Maintenance and care
Cleaning:
• Switch off the shredder, pull out the mains
plug.
• When cleaning only use a soft cloth and
a mild soap-water solution. Never use
scouring agents, cleaning fl uid, petroleum
or thinners.
When the cutting capacity drops or
the noise increases (only OS 550.2):
• Switch paper shredder off:
Tap rocker switch pos. 2.
2
• Spray special cutting block oil
through paper feed opening
across the whole width of the cut-
ting system blades.
• Run cutting system backwards
2
(pos. 2) without feeding paper.
• Paper dust and particles are
shaken off.
OS 500.2 / OS 550.2
9
Publicité
