Publicité
Fig . 4
Set screw
Loosen
Collar
Rack
Note: Make sure there is enough clearance to allow the table to rotate around the column.
The collar must sit loosely over rack and not angled on the column. To avoid column or collar
damage, only tighten the set screw enough to keep collar in place.
7. Insert the crank handle onto the worm shaft on the side of the table support. Make sure the
set screw is aligned on the flat of the shaft and as close to the table support as possible.
Tighten the set screw clockwise with the provided 3 mm hex wrench (Fig. 7).
8. Position the table in the same direction as the base, and tighten the table support lock
handle clockwise.
Fig . 6
Tighten
Set screw
Install drill press head onto
column (Fig . 8)
1. Lift the head assembly carefully and place
the mounting hole of the drill press head onto
the top of the column. Make sure the head is
seated properly on the column.
2. Align the head assembly with the base and
the table.
3. Tighten the two set screws with the provided
4 mm hex wrench.
Table support
Table
support
lock
handle
Bevel
Fig . 5
Fig . 7
Tighten
Lock handle
Set screw
Crank handle
Fig . 8
Worm
shaft
Groove
Lip
Tighten
Set screws
4 mm hex wrench
17
Publicité
