Publicité
1. Place the ramp (20) on the trailer bed and use M10 x 20 (18) bolts and nuts to fasten the hinge
plates (21) and ramp to the rear of the trailer bed, DO NOT over-tighten until the lock nut grabs and
bolt turns freely.
2. Lift up the ramp and lock to the UP position.
NOTE:
Please check and tighten all bolts before finalizing the assembly.
3. At this point your trailer will be fully assembled. (Fig. 10)
ASSEMBLY
ASSEMBLY
STEP 11
STEP 11
RAMP AND HINGE ASSEMBLY
Item N
Description
o.
18
Hex M10 x 20 bolts & nuts (set)
20
Ramp
21
Hinge plate
Qty.
4
1
2
Fig. 10
15
v.201016
Publicité
