Publicité
Charging the Battery
1. Press the push lock buttons on the battery to pull the
battery pack out of the equipment (Fig. 1).
Fig. 1
Push lock button
(on both sides)
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
Fig. 2
3. The battery will take approximately 1 hr 20 min to charge.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
This charger does not automatically turn
off when the battery is fully charged. Please take care not
to leave the battery plugged into the charger. Switch off or
unplug the charger at the mains when charging is complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the battery
Assembly
Before using the cordless grass trimmer, follow these
instructions to assemble.
m
WARNING!
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
Connect the Poles
1. Connect the poles by inserting the upper pole assembly
into the lower pole assembly (Fig. 3).
Fig. 3
Upper pole
assembly
Pole collar
Battery
indicators
2. Screw the pole collar on the thread to secure the poles
(Fig. 4).
Fig. 4
Pole collar
9
Do not insert the battery until assembly is
Lower pole
assembly
.
Publicité
