Publicité
Fitting the Safety Guard
m
WARNING!
The safety guard must be properly installed.
The safety guard provides partial protection from the risk of
thrown objects to the operator and other bystanders.
1. Fit the safety guard in the groove on the motor housing,
as shown (Fig. 5).
Fig. 5
2. Hold the blade hub in place, use the safety guard screw to
fix the safety guard in place, as shown (Fig. 6).
Fig. 6
Safety guard
Operation
The cordless grass trimmer is designed to cut grass and
weeds under bushes, and on slopes that cannot be reached
with the lawn mower. The trimmer must be used outdoors
only, at an ambient temperature between 41ºF (5ºC) and 113ºF
(45ºC).
m
WARNING!
Remove stones, small sticks and other
objects from the cutting area. The nylon blade will continue
to rotate for a few seconds after the trimmer is switched off.
Let the motor come to a complete stop before switching the
trimmer back on. Do not rapidly switch the trimmer off and on.
Safety guard
Groove
Safety guard
screw
m
WARNING!
Rocks or debris may ricochet or be thrown
into eyes and face, cause blindness, or other serious injury.
Never lean over the trimmer head and always wear eye
protection.
ON/OFF Switch
1. Insert the battery into the battery compartment on the
back of the machine. Press until it clicks into position.
Press and hold the safety lock button, then squeeze the
ON/OFF switch. When the machine runs steadily, release
the safety lock button (Fig. 7).
Fig. 7
Safety lock button
On/Off switch
2. To switch OFF, release the ON/OFF switch (Fig. 7).
Remove the battery.
Adjusting the Auxiliary Handle
1. Switch off the machine and remove the battery. Wait until
the blade comes to a complete stop.
2. Rotate the auxiliary handle knob counterclockwise to
loosen the auxiliary handle (Fig. 8).
Fig. 8
Auxiliary
handle knob
3. Adjust the position of the auxiliary handle as needed by
sliding it along the upper pole (Fig. 9).
4. Adjust the angle of the auxiliary handle as needed by
pivoting it as shown (Fig. 9).
10
Auxiliary handle
Publicité
