Programming; Activate / Deactivate Programming Mode; Programming Scenes; Programming Chases - involight The Commander Série Mode D'emploi

2.6 Programming:

2.6.1 Activate / Deactivate Programming Mode:

After power on, the unit is in manual mode.
1. Hold down the / REC / ENTER / key for two seconds. The display shows "Program". It is possible to create
scenes (scenes) or run lights (chases).
2. To turn off the programming mode, press and hold the / ENTER / REC / -Key again for two seconds. The
display shows "Manual" again.

2.6.2 Programming scenes:

There are 36 storage spaces for lighting scenes. Each scene contains the values of all control channels, including
possible pan and / or tilt movements of the connected headlights.
1. Activate the programming mode
2. Press the / SCENE / Key
3. Create a lighting scene (See Section 2.5.1 Creating Scenes)
4. Press the / REC / -Key and one of the numeric keypad to select the desired memory location. If necessary, use
the Key PAGE to switch between the storage locations:
Page A: Memory location 1-12
Page B: Memory location 13-24
Page C: Memory location 25-36
To confirm the memory, all the lights on the console flash three times.
5. Repeat steps 3 to 4 to store more scenes. The LEDs of the occupied memory lights.
6. To delete a scene, press and hold the / BLACKOUT / DEL / key and use the numeric keypad to select the scene
you want to delete.

2.6.3 Programming chases:

For programming chases, 36 memory locations with a total of 100 scenes are also available. The previously stored
scenes can be compiled and stored in a sequence to a running light.
1. Activate the programming mode.
2. Press the / Chase / Key.
3. Use the numeric keypad to select the desired memory location. If necessary, use the Key PAGE to switch
between the storage locations:
Page A: Memory location 1-12
Page B: Memory location 13-24
Page C: Memory location 25-36
The display shows: e.g.
Program
Chase:01: Step:001
4. Create a lighting scene (See Section 2.5.1 Creating Scenes)
5. Press the / REC / key. To confirm the memory, all the lights on the console flash three times.
6. Repeat steps 4 to 5 to store more scenes.
7. To delete a scene, press / BLACKOUT / DEL / -Key. To confirm the deletion, all the lights on the console flash
three times.

2.7 Selecting programs:

The programmed scenes and run lights can be selected in manual mode. In the case of lanes, you can choose to
run them manually, music-controlled or timed. It is possible to select several scenes and run lights at the same
time.

2.7.1 Selecting scenes:

1. Press the / Scene / key.
2. Use the numeric keypad to display the desired scene. You can call multiple scenes at the same time. If
necessary, use the Key PAGE to switch between the storage locations:
26