Delete All Dmx Assignmets; Reset To Factory Settings; Operation; Creating Scenes - involight The Commander Série Mode D'emploi

When you press the / SWAP / Key, the unit's UID (manufacturer ID and serial number) is displayed on the top line
of the display.

2.4.8 Delete all DMX Assignmets:

All address assignments and control channel options can be deleted and reset to the default settings.
1. Call the menu item "03. Delete all Fixture patch ". (See section 2.4.1 Menu structure)
2. Press the / ENTER / -Key. The display shows "DEL ALL PATCH [NO]"
3. Use the Pan dial to select [YES] when the erase operation is to be performed.
4. Confirm your settings with ENTER

2.4.9. Reset to factory settings:

Here, the device can be reset to the factory settings.
Note: All programs and headlight assignments are deleted!
1. Call the menu item "02. Reset factory ". (See section 2.5.1 Menu structure)
2. Press the / ENTER / -Key. The display shows "RESET FACTORY [NO]"
3. Use the Pan dial to select [YES]
4. Confirm your settings with ENTER

2.5 Operation:

After power on, the unit is in manual mode.

2.5.1 Creating Scenes:

A lighting scene contains the values of all control channels, including possible pan and / or tilt movements of the
connected headlights.
1. Use / FIXTURE / -Keyn to select the devices to be controlled. It is possible to control up to 24 spotlights with up
to 26 channels each with "SHOWControl". The 24 headlights are distributed on 3 sides. If necessary, use the /
PAGE / -Key to switch between the device pages. The LEDs A, B and C indicate which side is selected.
Note: You can enable successive devices at the same time. Press the first and last key simultaneously.
2. Use the sliders to set the DMX values for the selected devices. The current DMX value is shown in the display.
You can enter color blends via the HSV control, pan and tilt movements via the encoder wheels (the / Wheel to
Ran / Tilt / -Key must be active). DMX channels are grouped into 3 groups to 8 channels. If necessary, use the /
Page Up / and / PgDn / -Kyn between the channel groups.

2.5.2 Setting movement patterns:

The integrated effect generator allows you to display 8 different movements for the pan and tilt of moving heads or
scanners.
1. Use / FIXTURE / -Keyn to select the first spotlight to be assigned an effect. If necessary, use the / PAGE / -Key
to switch between the device pages
2. Enter the effect mode with the / MOVEMENT / -Key.
3. Use the numeric keypad (1-8) to select the desired movement.
4. Use the / RUN MODE / -Key to toggle between the parameters and use the pan / tilt wheels to set the values.
The available parameters:
[Movement Range] - Movement radius of the pan and tilt movement.
[Movement Offset] - center point of pan and tilt movement.
[Movement Speed] - Drain speed of pan and tilt movement.
[Delay Level] - Delay time for movement between individual moving heads.

2.5.3 Set color effects:

1. Use / FIXTURE / -Keyn to select the first spotlight to be assigned an effect. If necessary, use the / PAGE / -Key
to switch between the device pages
2. Enter the effect mode with the / MOVEMENT / -Key.
3. Use the numeric keypad (9-12) to select the desired color effect.
4. Use the Tilt dial to adjust the speed of the effect
25