Publicité
EN
FR
INSTRUCTIONS FOR BLIND RIVETS
This tool allows you to fasten rivets from
below diameters:
• Ø 2.4mm – 3/32"
• Ø 3.0/3.2mm – 1/8"
• Ø 4.0mm – 5/32"
• Ø 4.8mm – 3/16"
For this use, your tool must be equipped as
below picture:
1. Drill a hole in the appropriate location of
the workpiece.
2. Select one of the 4 noses adapted to the
rivet's diameter.
3. Open the grips.
4. Insert the rivet's rod into the nose and put
the rivet's body into the hole.
5. Close up the grips. Repeat this operation
until the rod breaks.
6. After the rod break, open the grips to eject
the rod.
2 •
MULTI-100 - User Manual
ENGLISH
INSTRUCTIONS FOR NUTS
This tool allows you to fasten nut from below
diameters:
• M3
• M4
• M5
• M6
For this use, your tool must be equipped as
below picture:
1.
Drill a hole in the appropriate location of
the workpiece.
2.
Select the tie rod adapted to the nut's
dimensions.
3.
Open the grips.
4.
Screw the nut on the tie rod. The tie rod
must exceed a little bit the nut's length.
5.
Put the nut into the hole.
6.
Close up the grips to fasten the nut.
7.
Open the grips and turn the back wheel
clockwise to release the nut.
Publicité
