Publicité
2.4 LCD Display Wording Index
Abbreviation
ENA / DIS
ESC
ON
OK
EP
AO / AC
TP
CH
SF
EE
BR
ST1 / ST2 / ST3
2.5 UPS Setting
Parameter 1
Interface
01 Output Voltage Setting
02 Programmable outlets enable/disable
03 Programmable outlet settings
Display Content
/
/
St1 / St2 / St3
Parameter 2
Setting
For EU Models you may choose 208/220/230/240 VAC settings
230VAC is the default. (Changing this setting is not recommended)
For US Models you may choose 110/115/120/127 VAC
120VAC is the default. (Changing this setting is not recommended)
ENA > Programmable outlets enabled
DIS > Programmable outlets disabled
Set up the backup time limits in minutes from 0-999 for programmable out-
lets which connect to non-critical devices on battery mode. (Default = 999)
Definition
Enable / Disable
Escape
ON
OK
EPO
Active Open / Active Close
Temperature
Charger
Site Fault
EEPROM Error
Battery Replacement
Input Waveform Sensitivity Setting
There are 2 parameters to set up the UPS
1. For program alternatives (Refer to table below)
2. Setting options or values for each program
Publicité
