Publicité
• Cleaning and user maintenance shall not be made by children.
• Use attachments/accessories specified by the manufacturer.
• Perform service maintenance by qualified personnel only.
3.2- Additional safety rules for electric power tool
• When the tool is not in use or before performing cleaning, turn it off and disconnect from
main power source.
• Never leave the product running unattended.
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases or dust.
• Maintain labels and rating plate through the life of service.
• Do not use the power tool if the switch does not turn on and off. Any power tool that cannot
be controlled with the switch is dangerous and must be repaired.
• Do not use a power tool while you are tired or under the influence of drugs, alcohol or
medication.
• Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp edges or moving parts.
• Store idle power tool out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool.
• If the power cable is damaged, it must be replaced by the manufacturer, its after sales
service or a person with similar qualification in order to avoid any danger.
3.3- Special warnings when using this electric pump
• The pump is designed for pumping clean water medium only. Do not use the pump to
deliver salt water, flammable, toxic, corrosive or irritant fluids.
• Do not use the pump when someone or pet is in the water.
• Before putting the pump into operation, make sure a residual current circuit breaker (RCCB)
with a rated tripping current not exceeding 30mA be installed.
• When installing, keep proper footing and balance at all times.
• The pump can be connected to shock-proof plug by professional electrician.
• All power plug and extension cable used with this equipment must be of suitable waterproof
rating.
• Make sure the pump is operating in upright position and there is sufficient space for the
functioning of floating switch.
• Do not move the pump while it is working.
• The temperature of the fluid to be pumped may not exceed 35 °C.
• Never direct the discharge flow towards any persons, animals, electrical wiring or
equipment.
• Do not use the tools in any operations that beyond the intended purpose.
IV. GETTING STARTED
4.1- Unpacking
• Remove the product from packaging
• Check if the product and accessories (if any) are intact.
Page 9 / 20
Publicité
