Publicité
CONNECTIONS FOR THE STANDBY CONTROL
SV-237 MK II
Many devices which can be controlled by a switching signal (not preamplifiers or
integrated amplifiers), have two terminals which do not differentiate between input and
output. In this case either of the two can be selected.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be inter-
connected! All receiving devices must not be connected to more than one preamplifier or
integrated amplifier (directly or indirectly)!
A set of headphones equipped with a 6.3 mm jack can be plugged into the socket "PHONES" (11) on
the front of the appliance.
SV-237 MK II
By doing this, the loudspeakers are switched off. All headphones with an impedance of between 32
Ohm and 600 Ohm may be used. Unsuitable headphones with too low impedance may damage the
amplifier or produce such unexpectedly loud volume that your hearing may be damaged. The volume
(5)(25) should be reduced for safety reasons before a set of phones is connected.
(POWER CONTROL)
power control cable
CONNECTION OF HEADPHONES
e.g. CD player
e.g. main amplifier
41
Publicité
