Télécharger Imprimer la page

Flame King VT-101CGA Manuel De L'utilisateur Et Mode D'emploi page 2

Publicité

INSTRUCTIONS (English)
PREPARATION
1. ALWAYS place stove on a flat, level, solid surface.
2. Open lid and raise wind screen panels. Insert wind screen tabs
into slots on lid, lock into place. (Fig. 1)
3. Make sure burners are in the off position.
4. Push regulator assembly firmly into the stove. Tighten nut securely.
5. Screw a portable propane cylinder onto the regulator.
6. This disposable propane cylinder will function most efficiently,if the
bottle is standing like Fig.2,this will allow the most efficient
withdrawal of fuel from the cylinder under most conditions.
7.The cylinder attach to stove valve see Fig,2a;The cylinder
dissaemble from stove valve see Fig,2b.
DO NOT place hands or other body parts over burner
during lighting or when in use to prevent burns.
OPERATION
1. Hold a lit match or extended lighter near the base of a stove
burner.
2. Slowly open the ON/OFF stove valve. (Fig. 3)
3. Adjust flame to the desired height. Flame should be compact and
blue in color.
4. Avoid getting dirt in valves, regulator and burners.
5. To shut burner off simply turn the control knob to the "off" position
(clockwise).
6.The gas cylinder must be disconnected for the appliacne after use
or when in storage.
CLEANING
1. Allow the entire stove assembly to cool completely.
2. Remove the propane tank from the stove.
3. Remove grate from the stove.
4. Wipe down with soapy water and rinse thoroughly. Do not use
abrasive materials.
5. A thorough cleaning is recommended after every 10 hours of use
or sooner if burners become overly dirty.
6. Prior to each use, check to see that all gas ports on burner are
WARNING
clean and operating properly. If not, remove from fuel source and
clean before usage.
7. No other maintenance is necessary or recommended by the
manufacturer.
STORAGE
1. DO NOT leave your propane tank attached to stove when not in
use.
2. After stove has cooled completely, remove propane cylinder.
Firmly grasp the fuel supply line and carefully turn the propane
cylinder in a counter clockwise direction.
3. To remove the regulator assembly, rotate the brass fitting in a
counter-clockwise direction. A slight tug may be required after it is
unscrewed to pull the tube out of the stove.
4. Store regulator assembly under the grate.
5. Unlock wind screens and fold down.
6. Close lid and latch closed to transport or store.
SERVICE AND REPAIR
This product is a sealed unit and is not designed for repair by the
customer. Do not attempt to service the stove or hose and
regulator assembly in the field. Contact the manufacturer for
service or warranty questions at: 1-800-421-6131.
NOTE:
Pots with concave bottoms are not recommended for use with
portable camp stoves. Concave bottoms can slide off wire cooking
grate when pot is heated.
DANGER
EXPLOSION - FIRE HAZARD
Never store propane near high heat, open flames, pilot
lights, direct sunlight, other ignition sources or where
temperatures exceed 120°F (49°C).
Propane is heavier than air and can accumulate in low
places. If you smell gas, leave the area immediately.
WARNING
do not leave this appliance unattended while it
is in operation. Keep children and pets away
from the appliance at all times
the minimum environmental temperature for safe
storage and operation of the appliance:-10℃~ 35℃
BURN HAZARD

Publicité

loading