Publicité
E N G L I S H
Conductor size (mm
2
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
220/240
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Inserting and removing a bit (fig. A)
• Align the pilot hole (6) in the chuck (1) with an
opening in the chuck guard (7).
• Insert the chuck key into the pilot hole (6).
• Open the chuck jaws (8) by turning
counterclockwise.
• Insert the shank of a bit into the chuck.
• Tighten the chuck using all three holes.
• To remove the bit, proceed in reverse order.
Chuck key holder (fig. D)
Your DeWALT Heavy Duty Right Angle Drill is
supplied with a chuck key holder.
• Fit the chuck key (5) to the chuck key holder (4)
as shown.
Instructions for use
Always observe the safety instructions
and applicable regulations.
en - 4
All manuals and user guides at all-guides.com
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
Prior to operation:
• Insert the appropriate bit.
• Mark the spot where the hole is to be drilled.
Switching ON and OFF (fig. A)
• To run the tool, press the paddle switch (2).
• To stop the tool, release the paddle switch.
Tool handling (fig. B)
60
Thanks to the paddle switch the drill can be used in
various positions as illustrated for optimum control
6
10
and comfort.
15
20
Consult your dealer for further information on the
25
appropriate accessories.
-
-
-
Maintenance
6
6
Your DeWALT Power Tool has been designed to
6
6
operate over a long period of time with a minimum
15
of maintenance. Continuous satisfactory operation
15
20
depends upon proper tool care and regular cleaning.
-
Chuck removal (fig. C)
• Insert the straight end of the chuck key handle
into the chuck (1).
• Strike the key (5) sharply in a counterclockwise
direction using a wooden mallet or similar object
to loosen the chuck.
• Unscrew the chuck by hand.
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized DeWALT repair
agent where it will be disposed of in an
environmentally safe way.
Publicité
