Publicité
OPERATION
Turning a Zone On/Off
You can turn any zone off if you do not wish to have alarms from that area go off for a period of time. To turn a zone
on or off:
1. Press any zone LED button once to turn that zone off, you will hear two beeps and the LED
will go out when the zone is off.
2. Press any zone button again to turn that zone back on, you will hear a single beep and the
LED will light up again.
Note: If there is no change in the LEDs (they stay off even when pressed) you may have the LED On/Off switch
on the side of the receiver set to Off.
Adjusting the Alarm Volume
1.
To adjust the volume of the alarm that sounds, turn the volume wheel left or right. Setting the volume to the
lowest setting will turn the alarm volume completely off.
Connecting an External Alarm
This system is capable of having a 3 wire connected external alarm. By connecting another alarm you can expand
your security system with a louder sounding alarm, or any other 3 wire connected system you choose. To connect an
external alarm:
1. Connect the three wires to the connections of your external alarm according to the alarm's instruction manual.
2. Using a small screwdriver or pin, push down
one of the connection buttons on the top of
the receiver, doing this will allow you to place
a wire in the connection; release pressure on
the button to secure the wire.
3. Repeat this process for all three wires, once
finished, power on the system and test.
INSTALLATION
Installation Recommendations
Before installing the sensor unit there are several things you should consider:
•
This system is water resistant, not waterproof. Installing it in an area where it is under an awning or covering is
recommended
•
Choosing the sensitivity level, either 15 feet or 30 feet, depending on where the sensor will be mounted, the
sensor will detect objects within a 30° angle
•
Where the sensor will be placed, must be within a 300 foot line of sight range from the receiver
Hanging the Sensor Unit
You will need an object such as a post or tree to screw the hanging clip to.
2. Screw the hanging clip to the post using 3 screws.
AL101
3 Wire External Alarm Connection
8
Publicité
