Publicité
INSTALLATION
2. Once you have the hanging clip secured to the post, hang the
sensor unit by first placing the flat edge under the plastic loop
on the battery compartment cover. Then clip the bottom of the
hanging clip around the bottom of the sensor unit.
3. Fasten the sensor to the bottom of the hanging clip using the
included screw and a phillips head screwdriver.
4. Once you have hung the sensor it is important to test its location
to ensure you have the proper sensitivity set.
Mounting Recommendation
•
To maximize vehicle detection, the sensor should be installed approximately 2-3 feet off the ground, pointing
on an angle so that it will view the vehicle from behind as it passes
INCORRECT ANGLE
Motion Sensor
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
FCC NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS
TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
IC NOTE:
LOW POWER DEVICES_RF
CLASS B OR A PRODUCTION
This Class [B] apparatus complies with Canadian ICES-003.
AL101
Plastic Loop
Hanging Clip
CORRECT ANGLE
Motion Sensor
9
Publicité
