Publicité
OPERATION
Powering On the Motion Sensor
The motion sensor requires 4 AA batteries to operate. Please see instructions below on how to install batteries and
mount your motion sensor properly.
• Once you have successfully installed the batteries in the motion sensor, the sensor will start up automatically,
please allow 60 seconds for the unit to initialize before it will begin sensing motion and sending signals
• It will be necessary to pair the motion sensor and the receiver before any alarms are received (see Pairing the
Devices below)
Installing Batteries in the Motion Sensor
This unit requires 4 AA batteries to operate. The unit is designed to operate on batteries for 6 months or longer before
they will need to be replaced. (Based on 10 alarms a day)
1. Remove the battery compartment cover on the back of the sensor unit using a small phillips head screwdriver.
2. Install 4 AA batteries.
3. While you have the compartment cover off, you should adjust the sensitivity to your needs (see Setting the
Sensor Sensitivity on Page 7) and pair the sensor to the proper zone, if you have not already done so. (see Pairing
the Devices on below) Replace the battery compartment cover.
Powering On the Receiver
The receiver unit can be powered using either the included power adapter, or by 4 AA batteries (not included).
Using the Adapter
4.
Plug the end of the adapter cable into any available wall outlet.
5.
Plug the other end into the 9V DC input jack on the left side of the receiver unit.
6.
Press the power button on the front of the receiver unit.
7.
When the unit is powered ON, a blue LED light will illuminate behind the power button.
Using 4 AA Batteries
1. Remove the battery compartment cover on the back of the receiver by placing your finger in the slot and pulling
the cover off.
2. Place 4 AA batteries in the battery compartment.
3. Replace the battery compartment cover.
4. Press the power button on the front of the receiver unit.
5. When the unit is powered ON, a blue LED light will illuminate behind the power button.
Pairing the Devices
The devices must be paired before the system will receive alerts.
1. Power on both units, press the pair button on the right side of the receiver.
2. The receiver will beep once and the first zone LED will blink. Choose which sensor you would like to monitor zone
1, and press the pair button inside the battery compartment of that sensor unit.
3. The receiver unit will beep twice and the chosen zone LED will stop flashing when the units have been paired.
AL101
Power Button
6
Publicité
