Publicité
The stopper is to prevent the drum to rotate in the direction
of impeller rotation. Follow the steps below to lock.
Figure 1. At center position, using standard chute. Note
the position of the lock.
Figure 3. Turn the drum to the left. The pin will slide over
the stopper .
To bring the drum to the center
Figure 5. Bringing the drum to the center will not
automatically lock the pin.
Proceed the same way if the drum is completely to the right, i.e. bring the drum to the left and bring it back to the center.
Use of the rotation drum stopper system
To guide the drum to the left :
Release the lock by turning the drum to the right.
Figure 2. Turn the drum a little bit to the right. The pin will
release from the stopper.
Figure 4. The drum completely to the left.
Figure 6. Slightly exceed the center of the drum and return to
the center. If the pin exceeds the stopper, the drum must be
brought back to the left and you should start again at figure
4.
9
Publicité
