Publicité
GB
and ducting kits are optional accessories and have to be ordered, they are not automatically supplied
with the chimney hood.
IN THE EXTRACTION MODE :
1. Fit the noise-reduction tubes over the round outlets on top of the canopy while pressing down until
they snap into position and then fit the non-return backflow flaps onto the top of the noise-reduction
tubes as illustrated Fig. 5.
2. Connect the ducting 150mm ( 6ins) and secure the connections with appropriate clamping rings or
adhesive tape.
3. Before fitting the chimneys to the canopy make the electrical connections as described in the section
titled ELECTRICAL. When the electrical connection has been made , test the lights and the fans mo-
tors.
IN THE REMOTE INSTALLATION MODE :
1. Connect the ducting 200 mm ( 8ins) onto the round outlets on the top of the canopy and onto the
round inlet of the motors at a distance and secure the connections with appropriate clamping rings
or adhesive tape.
2. Connect the earth connections onto the terminals marked with the earth symbol and clamp the con-
nectors onto the motors housing as illustrated Fig. 6.
IN THE RECIRCULATION MODE :
1. Connect the ducting 150mm ( 6ins) between motors and the recirculation spigot as illustrated Fig. 7
and secure the connections with appropriate clamping rings or adhesive tape.
2. Before fitting the chimneys to the canopy make the electrical connections as described in the section
titled ELECTRICAL.
FITTING THE CHIMNEY STACK
•
1. Each chimney stack consists of two sections. Fit the upper sections Fig. 1, Items 7 first by expanding
the chimneys slightly to allow them to clamp around the brackets items 2 and secure the chimney
stacks to the brackets using the four self tapping screws provided.
2. Fit the lower chimney sections by expanding the chimneys slightly to allow them from the top of the
canopy to clamp around the upper chimney sections.
4
OPERATION
A - EXTRACTION OR RECYCLING :Your cooker hood is supplied in the extraction mode. To use the cooker hood
in the recycling mode re-programme the hood as follows:
Starting in the recycling mode (the contaminated air passes into the hood through the grease filters and the
purifying activated charcoal filter and back out into the kitchen through grilles).
Press the '+' button (while the motor and lights are switched 'OFF') until the five LED lights will flash twice
to indicate confirmation that the cooker hood is in the recycling mode.
Reverting to the extraction mode (The cooker hood is ducted to the outside).
Press the '+' button (while the motor and lights are switched 'OFF') until the five LED lights will flash once
8
Publicité
