Publicité
Spout Supply Tube
Supply
Tube
Shoulder
Wood
Screw
2. Install the Spout Supply Tube
NOTE: Leave the protective sleeve on the spout supply tube until
the spout installation.
Drill a 7/8" D. (2.2 cm) hole at the proper location in the floor.
Slide the brass washer from the bottom of the spout supply tube
over the threads until the washer reaches the supply tube
shoulder.
Insert the spout supply tube through the mounting hole from the
top of the floor.
The flat portion of the brass washer should face forward. The
spout supply tube will be suspended by the brass washer.
Slide the plate (oriented with the tabs toward the deck) and
washer onto the spout supply tube from the bottom and thread
on the nut. Tighten the nut.
Secure the plate to the rough deck with two wood screws.
Slide the washer onto the supply tube and thread the nut on and
tighten it.
Ensure that the valves are closed (cold = fully counterclockwise;
hot = fully clockwise).
Install the tee to the supply assembly with solder if required for
the valves.
Plumb the supply to the supply tube using 1/2" Nom. or 5/8"
O.D. copper tubing.
Kohler Co.
All manuals and user guides at all-guides.com
Brass
Washer
Plate
Wood
Screw
Nut
Washer
Tee
5
1006092-2-B
Publicité
