Publicité
4. Close and lock the ring pin to secure the extender to
the auger shaft.
5. Align the holes in the auger shaft (9) with the holes
in the bit (7).
6. Install and lock the rig pin to secure the bit to the
extender.
WARNING
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the tool when assembling parts.
8.1.3 INSTALL THE BATTERY PACK
English
6
10
6
7
4
WARNING
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
•
Read, know, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.1.4 REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9
OPERATION
•
Touch the bit carefully.
•
Do not touch the bit unless you remove the battery
pack.
•
Do not use the machine if the bit is damaged or
bent.
•
Remove all objects such as cords, lights, wire, or
string which can become entangled in the bit and
create a risk of personal injury.
WARNING
If the bit jams on an electrical cord or line, DO
NOT TOUCH THE BIT! IT CAN BE LIVE AND
DANGEROUS. Do the steps below:
1. Hold the insulated rear handle or put the machine
down and away from you.
2. Disconnect the electrically service to the damaged
line or cord before you try to free the bit.
9.1
START THE MACHINE
1
2
3
This machine has three lights along the bottom of
the power head around the shaft. When the trigger is
9
EN
Publicité
