Publicité
HELPFUL TIPS
•
IMPORTANT! If the refrigerator has been placed in a horizontal or tilted position for any period of time, wait 8
hours before plugging the unit in.
•
It is recommended that you flush the hoses with water prior to first use to remove any dust and debris from
shipping.
•
Open the CO
Tank with a ¼ turn to start, then use the regulator to adjust to desired pour. If it is not enough,
2
continue to open the CO
•
It is normal to see condensation form on the faucet. It is caused by the difference in temperature between the
cold beer and the inside of the faucet when beer is flowing through the line.
•
Humidity can cause ice to build up inside the unit, so you will need to periodically defrost it. A hole in the back of
the unit will allow water to drain out of the appliance.
NOTE: Do not use sharp objects to remove ice build up as this may damage the unit.
Foamy Beer
Follow these steps to prevent foamy beer:
1.
Confirm the packing spring in the Keg Coupler is removed and discarded. It is not to be placed inside the Keg
Coupler when unit is assembled.
2.
Make sure there is only one Backflow Stopper inserted and it falls out easily if the Keg Coupler is flipped over.
If you have to force it out with a screwdriver, it is getting lodged in the Keg Coupler. Try exchanging it with the
included replacement.
3.
Confirm the beer lines are not kinked and are clean.
4.
You may need to adjust down your pressure, even if it is below the recommended 8-12 PSI:
•
Before lowering the pressure, close the CO
Allen Wrench to loosen the Allen Set Screw on the red +/- adjustment dial. This will restrict excess CO
from entering the keg.
•
Adjust the pressure down to 8 PSI or below. Lock the red +/- dial back in place by tightening with the Allen
Wrench.
•
Pull the Release Valve on the Regulator to get an accurate reading of CO
•
With the Shut Off Valve still closed, move down to your Coupler.
•
Pull the release valve on the Coupler to remove any excess CO
another point.
•
Once most or all has released, open the Shut Off Valve (6 o'clock position) and attempt to pour a beer.
5.
Keep in mind that jostling a keg can create foamy beer.
6.
Temperature also may affect the beer, so be sure it is not too warm or too cold. 3°C / 37°F is an ideal
temperature.
7.
A faulty valve on the keg itself may cause the Keg Coupler to not seal well. Make sure all connections are secure
and well tightened. Ensure all Washers are intact and correctly placed. Confirm the Directional Washer has a hole
in it when pinched between the fingers.
All manuals and user guides at all-guides.com
Tank by a ¼ turn and use regulator until desired setting is reached.
2
Shut Off Valve (turn to 9 o'clock position) and use a 1.5 mm
2
pressure.
2
that may have been pushed into the keg at
2
17
TM
2
Publicité
