Publicité
10
Product no. 399-6488-6
ATTACHING COUPLER TO REGULATOR
1.
If not already inserted, insert the CO
Directional Washer into the Keg Coupler.
Then screw the CO
Coupler.
ATTACHING REGULATOR TO CO
IMPORTANT! When you purchase your first keg of beer, you must also have your CO
CO
Tanks can be filled at locations such as welding supply shops, party stores, and wherever kegs are purchased.
2
1.
Align and hook the 4 holes of the
CO
Tank Holder with the screws
2
on the back of the unit.
3.
Use an adjustable wrench
(not included) to attach the
Regulator to the CO
All manuals and user guides at all-guides.com
2
Line onto the Keg
2
TANK
2
Tank.
2
2.
Hose
Clamp
Push the other end of the CO
the hole in the rear of the cabinet. Slide a Hose
Clamp onto the end of the CO
the hose to the barb fitting on the bottom of the
regulator. Secure the CO
Hose Clamp with a flathead screwdriver.
2.
Make sure the white nylon High
Pressure Washer (already installed)
is attached to the Regulator.
4.
Place the CO
Tank into the
2
CO
Tank Holder.
2
Line through
2
Line, then attach
2
Line by tightening the
2
Tank filled by a local supplier.
2
Publicité
