Publicité
INSTRUCTION MANUAL
English
Original manual. The product complies with Directive
2006/42/CE.
The Ultra Reef UCS range of calcium reactor integrates
and maintains the level of calcium and alkalinity within
an aquarium. The reactor is filled with calcium-based
media and continuously filled with aquarium water that
flows out slowly. Using the CO2 provided by the
connected vessel, it lowers the pH of the water that
recirculate in its interior to the point of dissolution of
the medium, which slowly consumes and release
carbonate and calcium ions (and other elements)
constantly in the aquarium.
Warning: The use of the product involves reading,
understanding and acceptance of all conditions set
forth in the "Safety" manual attached. If you do not find
that manual immediately, contact our office!
Clean thoroughly with water and vinegar (diluted to
10%) each component that will go into contact with
water. Products that contains alcohol or solvents can
damage the acrylic.
OVERVIEW
1- Cover
2- Media chamber
3- Base
4- Recirculation piping
5- Pump
Warning: Install the reactor inside the sump tank.
Connect the reactor only to CO2 cylinders suitable for
aquarium use and certified to comply with local laws.
Before perform installation, prepare the medium.
Follow the preparation instructions provided by the
supplier of the media.
Warning: This manual uses term "media" to indicate
the filling material of the reactor. We suggest to use a
media consisting of coarse coral sand
sand, calcium carbonate or aragonite, size 10-20 mm,
carefully washed.
Warning: We cannot guarantee the quality of the filling
materials produced by the different companies. Some
filling materials may release dust or incorrectly
dissolve, causing wear to pumps and impellers. The
necessary spare parts will not be considered under
warranty.
Remove the top cover and place the reactor inside the
tank sump. Spill into reactor earlier prepared media
and close the cover, without forgetting the gasket.
6
ULTRA REEF
www.ultrareef.it
of
coarse coral
Publicité
