Publicité
•
Do not use aggressive detergents or solvents to clean the plastic parts or
handgrips.
•
Do not spray water onto the motor and electrical components and prevent
them from getting wet.
•
To avoid overheating and damage to the motor or the battery, always keep
the cooling air vents clean and free of debris.
Clean and Lubrication of the Cutting Means
To increase the efficiency and working life of the blades, clean and lubricate them
carefully after each work session:
•
Place the machine in a stable horizontal position on the ground.
•
Use a soft cloth to clean the blades, along with a brush to remove more
difficult dirt and debris.
•
Lubricate the blades by applying a light layer of specific oil, preferably the
non-pollutant type, along the upper edge of the blade.
•
Keep all nuts, bolts and screws tight to be sure the equipment is in safe
working condition.
•
Check regularly that the handles are fixed firmly.
All manuals and user guides at all-guides.com
Troubleshooting
With the safety
lock button and
trigger on, the
cutting means
does not turn.
The cutting means
overheats whilst
working.
Excessive noise
and/or vibration is
experienced whilst
working.
The machine gives
off smoke whilst
working.
Technical Data
Cutting length
PROBABLE
PROBLEM
CAUSE
The machine is
Do not use the machine. Immediately turn
damaged.
off the machine remove the battery and
Contact a Service Centre.
Insufficient
Turn off the machine, wait until the cutting
blade
means is stationary, remove the battery
lubrication.
and lubricate the blades.
Loose or
Turn off the machine, remove the battery
damaged parts.
and:
– inspect for damage;
– check for and tighten any loose parts;
– have any damaged parts replaced or
repaired with parts having equivalent
specifications.
The machine is
Do not use the machine. Immediately turn
damaged.
off the machine remove the battery and
Contact a Authorised Service Centre.
PROPERTY
GB
EN
POSSIBLE SOLUTION
VALUE
466 mm
3
cramer.eu
Publicité
