NetSpa VITA PREMIUM Guide D'installation Et D'utilisation page 33

Press the heater button to activate water filtering and heating system. The red
indicator light will turn on.
The pump does not stop heating until the current water temperature reaches the
set temperature; and the heating system will restart after the current water tem-
perature drops 2°C below the set temperature automatically.
Maximum heating temperature: 42°C (108°F)
Important :
When the filtering system has worked 150 hours accumulatively, buzzing
will warn to remind you to clean the filter. You can hold the filtering button
5 seconds to turn off the buzzing. The heating system will turn off, you can
press the button to active the heating system again.
Note :
- The heating system is dependent on the filtration system and it can't operate without.
- If the massage function is active, the filtration and heating functions can be activated.
- The engine block is designed to operate 24 hours a day.
- The spa cannot be connected to a programmer because of its electrical protection.
EN
33