Control Panel; Functions - NetSpa VITA PREMIUM Guide D'installation Et D'utilisation

4. USAGE

4.1. Control panel

Screen

4.2. Functions

Once powered-up, the LED displays the current water temperature automatically.
The temperature units selector changes the temperature units from Celsius de-
grees to Fahrenheit degrees.
Press the temperature adjustment buttons, then the screen will flash. When it is
flashing, you can set the desired temperature. The value will increase or decrease
1 degree at once. The temperature could be set between 30°C to 42°C (86°F to
108°F).
Hold down the lock button 5 seconds to lock or unlock the control panel.
Lock the control panel when you are away to prevent other people come to
change your settings..
Press the massage button to activate the bubble massage system, the green
indicator light turns on. Pressing once will start the lowest speed (L-1 will display
on the screen). Press again to increase the speed to L-2 and press again to reach
the highest speed L-3. Hold down the massage button 5 seconds to turn off.
When massage function turns off, the heating function is back on.
Note :
- The massage system will stop automatically after 30 minutes of operation. Re-activate the mas-
sage function by pressing the massage button again.
- When filter button is on, pressing bubble button will exchange filter mode into massage mode: filter
indicator light will turn off and massage indicator light turn on.
32
Temperature
units indicator
Heater Massage
Increase
temperature
Temperature
units selector
Lock
Decrease
temperature