Publicité
Location of Controls
1.Thermostat control knob (TEMPERATURE SETTING)- Adjust to maintain room
temperature
2.Flame switch - Switches flame effect and power on/off.
3.Heating setting: please press "
4. Heating setting : please press"
operate without first press"
5.Flame dimmer control - Adjust to set flame intensity.
Assembly Instructions
Lay stove upside down on a padded surface with the underside accessible. Attach leg to
stove by inserting the tab on the top of the leg into the corresponding slot on the bottom of
the stove.
Insert screws into predrilled holes and tighten securely. Repeat with remaining three legs.
Overheating safe device
If the heater stops working, turn the heater off and inspect the blockage of inlet or outlet.
Disconnect the plug and wait at least 10 minutes for the protection system to reset before
attempting to restart the heater. If the safe device still switches the heater off and makes
the heater fail to operate, take the heater to your nearest service center for examination or
repair.
Attention: before restarting the heater, the plug must be disconnected for at least 10
minutes.
" for 750W.
"and "
"at the same time for 1500W (can not
" ).
Publicité
