Publicité
Operation
Before Using the Chain Saw
Before using the chain saw, do the following:
•
Clean and check the chain components for
excessive wear or damage and replace them as
needed; refer to
Servicing the Guide Bar, Chain,
and Drive Sprocket (page 18)
Chain (page
20).
•
Check the oil level; refer to
and Adding Bar and Chain Oil (page
•
Check the chain brake; refer to
Chain Brake (page
Starting the Chain Saw
1.
Make sure that the vents on the chain saw
(Figure 5
and
Figure
debris.
1. Vent
1. Vent (inside the battery
cavity)
2.
Set the chain saw down on a level surface.
3.
Align the tongue of the battery pack with the
battery cavity in the chain saw
All manuals and user guides at all-guides.com
and
Sharpening the
Checking the Oil Level
17).
Checking the
17).
6) are free from dust and
Figure 5
Figure 6
2. Vent
(Figure
7).
4.
Push the battery pack into the battery cavity until
the battery pack locks into place.
5.
Ensure that the chain brake is in the O
position
(Figure
1. Chain brake (O
position)
g197204
6.
With 1 hand on the front handle and the other
on the rear handle, press the trigger lock, then
squeeze the trigger
g197205
1. Front handle
2. Chain brake
9
Figure 7
8).
Figure 8
2. Chain brake (
PERATING
position)
(Figure
9).
Figure 9
3. Trigger lock
4. Trigger
g192108
PERATING
g192111
STOP
g192113
Publicité
