Publicité
8.1 Assembly on motor
Screw contra angle handpiece on motor.
Please note, that the shaft of the contra angle handpiece engages correct into the driver of the motor.
8.2 tool change
When opening and closing the chuck please make sure that there is a tool in the chuck!
1. Fix wrench art.no. 10151 (1) on one of the key surfaces of the chuck
2. Fix the axle with the key art.no. 10147 (2)
3. Solve the chuck with wrench (1) so far until the tool can be easily removed
(1)
8.3 Remove chuck
Solve the chuck as described in 8.2. - after removing the tool - screw the chuck with the fingers counterclockwise
till it could be removed completely.
close
open
(2)
10
10
Publicité
