Publicité
After thoroughly cleaning the chuck, before replacing, it should be slightly greased on the outer surface
(e.g., with Vaseline).
Only fasten the chuck lightly when reinstalling! The chuck will fix itself firmly as part of its normal operation.
To optimise the precision and durability of the chuck, a tool or the factory supplied protective pin
must always be fixed, even when not in use.
Never clean the handpiece with compressed air!
The required chuck keys are located in the underside of the handpiece holder.
6.4.Removing / changing the motor cable (see picture page 6)
1. Unscrew the cap from the motor
2. Loosen the cable by pulling out the plug-in seal
6.5 Technical data
diameter max:
length:
weight without cable
weight with cable:
cooling:
drive system:
Concentricity:
chuck standard:
tool change:
The oscillation total value during operation is below 2,5 m/s².
30 mm
158 mm
240 g
370 g
self sealing system without cooling
brushless DC-motor
< 0,02 mm
ø 3,0 mm
quick release
7
7
Publicité
